How to Disable YOUTHWHISPER Smart DTag
Press and hold the button for 6 seconds.
You will hear two short beeps "di di", then release the button. A long beep will sound, indicating that the device has powered off successfully.
How to Re-enable YOUTHWHISPER Smart DTag
Single-press the button on the front of the accessory.
If the device is not paired, a short melody will play.
If the device is already paired, you will hear "di di di di".
Note: If the device is already enabled, a single press will only produce a key tone sound.
How to Enter UTP Identification Mode
1. Locate the button on the front of the accessory.
2. Press the button once.
3. A confirmation beep will sound.